Jump to content

Text and Polyline Intrsection mark


Recommended Posts

Does any body have any idea how can we find out the Text and Polyline intersection location using Autolisp?




It will be better if we can mark error circles on a perticular layer on the intersection.


Thanks in advance

Link to comment
Share on other sites

Easy done but a problem how do you want to interpret the Text angle and insert pt of text versus the pline ?


Is it always horizontal angle=0 ?


Do you just want to know if it hits not some actual point required. Like you have hinted with a circle.


Just make a temporary line for the text say through middle and use VL "Intersectwith"


Is it multiple Text and plines ? Need to iterate then through a list comparing.


Please post dwg.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...