Jump to content
DS-precast

parameter flips direction after setting to zero ??

Recommended Posts

DS-precast

Hello all

 

I am developing a parametric model of a precast stair using Inventor 2013. I have set a parameter call "rake" to define the rake distance of the stair (the distance the nosing of each tread protrudes over the tread below - usually about 25 mm) This is initially set to 25 mm in the sketch.

 

If there is no rake, I set this to 0 mm, and this gives a perfectly horizontal & vertical stair profile.

 

If I then set this back to 25 mm, Inventor flips (reverses) the direction and the profile produced is incorrect (it is like a negative rake angle).

 

I guess it is because when I set the rake to 0, the two points are directly in line vertically, and when I set it to 25 mm again it pushes them 25 mm apart horizontally, but in the wrong direction.

 

Is there any way to constrain these parameters or points such the distance is measured only in the desired direction, or to stop one point from going beyond the vertical position of another point.

 

Any help on this matter would be very much appreciated.

 

Many thanks in advance.

Share this post


Link to post
Share on other sites
JD Mather

I don't have time to find a previous discussion or work up a solution, but as I recall someone else had a similar problem that was solved by using a radius parameter on a construction circle (don't get confused on this - as I recall the radius didn't go to zero - it worked the other way around).

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...