Jump to content
d1212

MLine keep fill after explode

Recommended Posts

d1212

Hello Community,

 

is there a way to keep the fill of a MLINE after I explode it? I'd like to have single LINES with a HATCH. Or is there a diffrent way to achieve this? I'd like to draw e.g. two lines with a solid hatch in between at once.

 

Thanks and kind regards

d1212

 

 

I use AutoCAD 2016

Share this post


Link to post
Share on other sites
Organic

I haven't found a way to do this although having needed this previously it would be very handy if there was a way.

Share this post


Link to post
Share on other sites
BIGAL

A custom pline routine would be the way to go offset 2nd line then close ends, and join then hatch. Need a couple of rules is it central or a left/right offest as you draw. There should be something already out there, I think I have seen something about closing two plines.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...