dpdan06 Posted September 7, 2011 Author Share Posted September 7, 2011 I'm not sure how to work that out in 2d to be honest Quote Link to comment Share on other sites More sharing options...
ReMark Posted September 7, 2011 Share Posted September 7, 2011 You would draw your frame, in section, then add the profile of one of your slats to get the angle. Then all you have to do is figure out what spacing your frame will accommodate. Quote Link to comment Share on other sites More sharing options...
f700es Posted September 7, 2011 Share Posted September 7, 2011 Again, if everyone pitches in and get's me a used Mac mini I will start supporting AutoCAD on mac for users My old one will not run it. Quote Link to comment Share on other sites More sharing options...
ReMark Posted September 7, 2011 Share Posted September 7, 2011 Donations may be sent to.......? Quote Link to comment Share on other sites More sharing options...
f700es Posted September 7, 2011 Share Posted September 7, 2011 paypal f700es@yahoo.com, where else I'll need a copy of AutoCAD for Mac too Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.