Jump to content

Duct lengths

The Santo

Recommended Posts

Can anyone tell me if I can split a run of duct into standard lengths automatically. The same as ACAD MEP, below:




I've already looked online but only see comments like split it manually which would be a bit of a pain with a complex building.


(I'm issuing full schedules to a fabrication company, I can't just send them GA type dwgs to take-off).



Ta' much.

Edited by The Santo
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...