Jump to content

Recommended Posts

ryankevin15

Hello,

 

So the following is an example of a very nice homerun. You can bend it and it'll move the arrow accordingly, reducing time spent drafting during clean up.

 

I'd like to make one similar to the one attached that will allow you to show the wires associated with the circuit.

 

For those not electrically inclined,

 

Long line = neutral

Short line = hot/1phase

Long line+dot = ground

 

I think it would be nice if you could bend the homerun like the one attached but also be able to change it using a dynamic block type setup where you can chose different circuit types based on what it is powering.

 

Is anyone savy enough with AutoCAD to do something like this?

 

Dynamic Homerun.dwg

Share this post


Link to post
Share on other sites
ryankevin15

bump bump bump bump bump bump

Share this post


Link to post
Share on other sites
Ski_Me

This is not really a block it's a leader and honestly not that hard to make. Create a block by using a spline and draw and arrow to being with then add parameters to it. Start there then see where your at.

Share this post


Link to post
Share on other sites
steven-g

It would help if you gave some idea of the type of thing you are hoping for. A couple of sketches or variations.

Dynamic Homerun (1).dwg

Share this post


Link to post
Share on other sites
Ski_Me

I like the block you made steven-g gonna use it.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...