Search the Community
Showing results for tags 'gaps'.
I'm using MEP 2010. In Schematics workspace, afters setting the gap width in the settings, the gap between two crossing schematic lines does appear in the drawing. Once the file is closed and reopened again, none of the gaps appear. However the gaps will appear in lines newly drawn in the same drawing but not in the existing ones. Is anyone familiar with this situation and does anyone know the solution?
Hey! I have tried to search solution to this gap problem but with no success. AutoCAD generates gaps to my drawing, sometimes there is NO gap and then it says there is when I'm selection new are to hatch (puts the red circle to old place where it didn't earlier say there is gap!). I have tried to use Gap Tolerance tool first with value of 10 but it didn't work. After that I changed it to 1000 and it worked but the hatch area wasn't good. I also tried to pull line over other and trim it, didn't work either. Used also join but it didn't work... I have used object snap always when I drew the picture. I have zoomed as much I can and there is no gaps. I'm so confused! What to do? Thanks in advance! Uploaded with ImageShack.us Uploaded with ImageShack.us